Oreska - Užice

Pri svakom konektovanju mi se pojavljuje sledece :

One or more requested network protocols did not connect succesfully.

TCP/IP CP connected successfully.

IPX/SPX  or compatible CP reported error 733: A connection to the remote computer could not be completed.You might need to adjust the protocols on this computer.For further assistance, click More info or searach Help and Support Center for this error number.

Press Accept to use the connection as is,or Hang Up to disconnect.

 ? Do not request the failed the failed protocols next time .


                 Accept                                           Hang Up

Ako je modemska veza prema internetu, iskljuci IPX/SPX i sve ostale protokole, a ostavi samo TCP/IP.

Pri pokusaju konekcije desava se sledece:

Error 718

A Point to Point Protocol (PPP) connection was initiated but could not be completed because the remote computer did not respond in a timely manner or it did not give a valid response. This can occur for any of several reasons:

   If you are trying to establish a connection to a virtual private network (VPN), try entering your domain name and your user name in User name as follows: DOMAIN\username
, and try again to establish the connection.

   If you are trying to establish a connection to a remote network, network congestion or a network device (such as a firewall) might be blocking your attempt to make a connection. Try your connection later, or contact the administrator of the remote network for more information.
   You might need to install updated drivers for your modem, your network card, or another connection device. For more information, contact your hardware manufacturer.

Verifing username and password....... i stop.

Promenom PPP type of dial-up server I am calling na SLIP:Unix Connection veza je uspostavljena.
Sta se desava ?Kako ovo da resim a da mi bude sve default?Nije u pitanju firewall.
Veza je modemska.Instaliran samo Internet protokol TCP/IP.
Ima li neke bitne razlike izmedju PPP i SLIP?
Jednostavno sta mi valja ciniti?

Hvala!!!

Ovu poruku saljem inace preko 042 PTT konekcije koja je ostvarljiva.

Obichno kad se poskidaju i instaliraju nanovo protokoli ili dial up networking sve proradi, sad ne znam... probaj..

STo ne proveris sa onim ko administrira racunar na koji se povezujes ppp-om. One ce najpre znatikako je podesio PPP a imace ulogu vise detalja o neuspeloj konekciji.

Cackanjem sam napravio jos gore.
Ne znam kakve veze to ima sa Start menijem ali sada pri restartovanju nemam vise ona tri lepa dugmica sa log off, turn off, restart vec se otvori neki prozor sa ponudjenim tim opcijama .Kao i pri startovanju takodje mi se otvori prozor koji trazi neki password to log on microsoft koji mi pre ovoga nije ni trazio.A i ako ne ukucam password  to me nista ne koci.To je meni dovoljan znak da sam nesto zeznuo.

Sta je sledece?Izaci ce nesto iz racunara i pocece da me bije?!

Ja se samo sluzim racunarom i nikada ali slovima NIKADA do sada nisam imao potrebu da cackam te protokole.A kod podesevanja tog protokola mogu se samo cekirati 3 stvari:

1. Enable LCP extensions
2. Enable software compression
3. Negotiate multi - link for single link connections.

Ja sam zatekao cekirane prve 2 stvari.3 je ostala prazna tj. nije cekirana

Bogme, univerzalno resenje za tvoje probleme je format :)

Radi Bog te vid'o.RADI!!!!!!!!!!Kako sam to uradio ne znam ,ali zar je bitno?!!

Samo mi jos ostaje da vratim na normalno resetovanje i bombona!!!!!

SAMO?????????

Divim se samom sebi do imbecilnosti.

Navedeni problem pri restartovanju se resava jednostavnim podesavanjem u User accounts - Change the way users log on or off.

Kakve ovo veze sa protokolom ima ja to ne bih znao reci.

Da i ja kazem neko resenje na ovom forumu.